NUOVA FILP CARBIDE CYLINDRICAL ROUNDED HEAD ROTARY BURR TYPE B

Large cutting edge with chamfered corners. Ensures lower vibration and optimum drilling performance in reinforced concrete applications. Longer bit life over time.

4 x 90° head geometry. Allows precise holes and excellent drilling performance, even when reinforcement is present.

130° Primary Cutting Edge. The 130° cutting edge angle allows optimum performance in applications where reinforcement is present and excellent hole accuracy.

Secondary Cutting Edge. Robust, to support the primary cutting edge during drilling, for faster drilling.

Short flute for better dust extraction and faster drilling speed, less wear and less heat build-up.

Thicker Primary Cutting Edge with a higher percentage of carbide, and on Ø > 32 mm a further higher percentage of carbide for longer life.

Groove located at the side of the primary cutting edge, which allows the wear of the bit to be checked. Milwaukee guarantees its bit up to 75 m.

Reinforced bit section. This gives lower vibration, fewer breakages and the best transfer of the tool's power to the bit.

Deep flute shoulder. This allows greater and faster dust extraction and less heat build-up on the bit head, and therefore less wear.

Lower Vibration. Comfortable drilling with less stress for the user and for the tool.

Special surface treatment. For easier dust flow along the bit surface and lower friction.

PGM Mark. Guarantees precise, accurate holes and maximum anchor holding strength.

Staples for M18 FFUS. Compatible only with the Milwaukee tool.

For all types of fences made of wood, e.g. livestock fencing, square mesh/chain-link/barbed wire and high-tensile wire.

Hot-dip galvanised coating for superior corrosion resistance.

4 mm thickness for the best durability in outdoor applications.

Sharp, divergent points: the staple point twists as it is driven into the wood, offering a better hold.

Red adhesive coating for improved drivability while maximising holding force.

Collated with paper tape.

4932430285

The jaws for M12™ and M18™ FORCE LOGIC™ press tools are designed to meet the highest standards of quality and durability. Thanks to the ability to open them easily with a thumb, these jaws are the most convenient and practical pressing solution for diameters of up to 108 mm.