HYDRAULIC PUMP RIGHT GROUP 1

The STM torque arm for U110 gearbox is designed to ensure the stability of the gearbox during operation, preventing unwanted rotation and ensuring correct alignment of the drive.

Large cutting edge with chamfered corners. Ensures lower vibration and optimum drilling performance in reinforced concrete applications. Longer bit life over time.

4 x 90° head geometry. Allows precise holes and excellent drilling performance, even when reinforcement is present.

130° Primary Cutting Edge. The 130° cutting edge angle allows optimum performance in applications where reinforcement is present and excellent hole accuracy.

Secondary Cutting Edge. Robust, to support the primary cutting edge during drilling, for faster drilling.

Short flute for better dust extraction and faster drilling speed, less wear and less heat build-up.

Thicker Primary Cutting Edge with a higher percentage of carbide, and on Ø > 32 mm a further higher percentage of carbide for longer life.

Groove located at the side of the primary cutting edge, which allows the wear of the bit to be checked. Milwaukee guarantees its bit up to 75 m.

Reinforced bit section. This gives lower vibration, fewer breakages and the best transfer of the tool's power to the bit.

Deep flute shoulder. This allows greater and faster dust extraction and less heat build-up on the bit head, and therefore less wear.

Lower Vibration. Comfortable drilling with less stress for the user and for the tool.

Special surface treatment. For easier dust flow along the bit surface and lower friction.

PGM Mark. Guarantees precise, accurate holes and maximum anchor holding strength.